They threaded their team, filling the coil and adjust tension

Image : http://www.flickr.com

1. Share your spool of thread on the spindle of the machine.

1a. A vertical shaft or post - the position of the coil, so that the yarn clockwise to sew.

1b. A horizontal axis - the coil is the place of a lid. If your reel has a small cut in it, you must have the cut on the right side.

TIP for beginners: If your tail is new and has tags for the holes to fully expose the coil yhour holes so as to make them easy to find.

2. Pull threadleft and the axis through its first thread guide.

3. Tie wire lead through your stress. (It is extremely important that you have the presser foot UP to maneuver on your computer.)

4. Draw run the thread through the next debate.

5. Insert the wire through the lever of the recording.

6. Bring to carry the thread through the following thread.

7. Finally! - Thread the needle. Most are equipped with threaded needles from front to back, some from left to right.

Practical Threading your machine. Nosmall task, if you are a beginner, but after a while, you will be able to do this with my eyes closed.

BOBBIN WINDING Step SU - The Next

Follow the instructions in your manual carefully when its coil winding.

If installed the spool, the coil in place with the machine will be completely covered by wire.

Detachable coils are on the top or side of the machine from the wound. The team must be threaded before filling the coil.

Your reel should be writtenuntil spring. To wind coils in place, it is done. You must ensure that this happens when you use a coil that already use it in a thread there.

Equilibrium tension:

Balancing your blood pressure is a big problem when you start learning about your sewing machine. There is nothing that causes more pain than your willpower.

Their sting is formed by blocking the spool of thread and needle. Each time the needle down, catches a snagneedle and thread is wrapped around the coil. It's a tug of war that must be synchronized to a good result in the lurch.

If the thread tension of the needle is stronger, the coil is pulled to the top of the fabric. If the voltage of the coil is stronger, the needle thread at the bottom of the visible structure. When the voltage is fair and balanced, the central point in the block, halfway between the top and bottom edges of the fabric. This is whatThey want and need to be found. It may take some playing with the tension guide, but it's worth the little time it takes.

TEST - TEST

The easiest way to test your thread tension is your machine and lit a colored thread your machine with a different color on your reel. No one should be with his material. It is necessary to see through his tricks.

If tension is too tight, you will see your coil.

If tension is too loose, youHis main problem at the bottom of the fabric.

If the voltage is correct, you are only machine thread at the top of the fabric and the coil only look at the bottom of the fabric.

Making adjustments:

Before the power to customize these three tests. This is very important.

1. Make sure your computer is properly threaded. Even long time, sew-ers can lose a guide wire.

2. Make sure the coil is installed correctly.

3. VerifyYour needle is inserted correctly.

After passing through the three controls may need to adjust the tension of sewing a stitch of good. Read your manual to see, here's how. Every time you have set, sewing more. You should only were small, simple adjustments to correct the mesh.

If, after what seems an eternity of change, have not balanced the lurch, leave the team. Not even look at them for a few hours, maybe a day or two. Then goback and try again. Could it be that they are tired, frustrated or distracted. It happens to everyone.

Or it could be adapted to their needs coil. Most sewing machine manufacturers do not want to adjust the tension of the coil. If the manual does not refer to this area, then it is best for your sewing machine to get a reputable dealer or repair man.

Sew Happy!